Vaisala DRYCAP DMT345 Uživatelská příručka stáhnout pdf (Strana 89)

Chapter 4 _________________________________________________________________ Operation

VAISALA ________________________________________________________________________ 89

Opening a Telnet Session (LAN/WLAN)

NOTE

The instructions below assume that the LAN/WLAN interface on the

transmitter is correctly configured and the network connection is already

done.

1. Power up the instrument and start the PuTTY application. If your

transmitter acquires a network address using DHCP, wait for a

minute for this to complete, then verify the address from the

transmitter.

2. In the Session window, select the Telnet connection type.

3. Enter the IP address of your transmitter in the Host Name (or IP

address) field. Use the default Telnet port 23.

0810-071

Figure 57 Opening a Telnet Connection

4. Click the Open button to open the connection window and start

using the Telnet session.

If PuTTY is unable to connect the IP address you entered, it will

show you an error message instead. If this happens, check the

IP address and the connections, restart PuTTY, and try again.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 184 185

Žádné komentáře

Vaisala DRYCAP DMT345 Uživatelská příručka Strana 89