Vaisala HUMICAP HMP46 Uživatelský manuál stáhnout pdf (Strana 3)

PCS-3000 Proofer Control System

Eliminate Proofer Temperature & Humidity Problems Forever! Designed for retrofitting your existing proof box

or fermentation room, the Cooke PCS-3000 state of the art control system eliminates all of the problems

associated with wet/dry bulb control systems.

• Maintenance is virtually eliminated.

• Better product quality and consistency.

• Reduced product waste & lost production.

• Closer control reduces fuel consumption.

• Eliminates unnecessary sling psychrometer checks.

• Troublesome start up condensate is prevented by a built in humidity lock out feature.

Your Plant Electrician can easily install the PCS-3000 following these three simple steps:

1. Drill a 1/2" hole through the side of the return duct and mount the combination temperature/humidity

sensor using only two screws.

2. Mount Nema 4X control box at any convenient location, connect AC power and pre-wired sensor cable.

3. Install four control wires from terminal strip in control box to control valves.

You're proofing in a matter of minutes! Leave your old system in place and run it parallel with the

PCS-3000 for a short time. This will allow production personnel to become acquainted with direct

RH readings rather than interpolating from a psychrometric chart. The PCS-3000 is maintenance

free and flexible. It can be field wired to control solenoid valves, proportional pneumatic or electric

motor actuated valves. You can easily add a recorder at any time.

1 2 3 4 5 6 7 8 ... 13 14

Žádné komentáře

Vaisala HUMICAP HMP46 Uživatelský manuál Strana 3