Vaisala WXT520 Uživatelská příručka Strana 51

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 171
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 50
Chapter 5 _______________________________________________ Wiring and Power Management
VAISALA_______________________________________________________________________ 49
Table 2 Screw Terminal Pin-outs for WXT520 Serial
Interfaces and Power Supplies
Screw Terminal
Pin
RS-232 SDI-12 RS-485 RS-422
1 RX- - - Data- Data in (RX-)
2 RX+ - - Data+ Data in (RX+)
3 TX- Data out (TxD) Data in/out (Tx) Data- Data out (TX-)
4 TX+ - - Data+ Data out (TX+)
5 RXD Data in (RxD) Data in/out (Rx) - -
6 SGND GND for data GND for data - -
17 HTG- GND for Vh+ GND for Vh+ GND for Vh+ GND for Vh+
18 HTG+ Vh+ (heating) Vh+ (heating) Vh+ (heating) Vh+ (heating)
19 VIN- GND for Vin+ GND for Vin+ GND for Vin+ GND for Vin+
20 VIN+ Vin+ (operating) Vin+ (operating) Vin+ (operating) Vin+ (operating)
NOTE
In the true SDI-12 mode the two Data in/out lines must be combined
either in the screw terminal or outside WXT520.
NOTE
Short-circuit jumpers are required between pins 1-3 and 2-4 for the
RS-485 communication mode. For the RS-422 mode, the jumpers
should be removed. In the other modes the jumpers may stay or they
can be removed.
Zobrazit stránku 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 170 171

Komentáře k této Příručce

Žádné komentáře