Vaisala DRYCAP DMT345 Uživatelská příručka stáhnout pdf (Strana 90)

USER'S GUIDE____________________________________________________________________

90 __________________________________________________________________ M210762EN-D

To select display units:

1. Open the MAIN MENU by pressing any of the ▲▼◄► arrow

buttons.

2. Press the ► arrow button to select Display.

3. Use the ▲▼arrow buttons to select Units. Confirm the selection

by pressing the right-hand arrow button.

4. Use the ▲▼ arrow buttons to select display units. Confirm the

selection by pressing CHANGE. The unit changes from metric to

non-metric or the other way round.

5. Press EXIT to return to the basic display.

NOTE

Changing the units by using the display/keypad has no effect on the

serial output units.

Using Serial Line

Use the serial line command FORM to change the format, and the

command UNIT to select metric or non-metric output units.

FORM

Use the serial line command FORM to change the format or select a

certain quantities for the output commands SEND and R.

Syntax: FORM [x]

where

x = Formatter string

Formatter string consists of quantities and modifiers. If no formatter

string is entered, the command will display the currently active formatter

string. Note that the hash symbol "#" is shown as a backslash "\" when

viewing the current formatter string.

When selecting the quantity, use the abbreviations of the quantities

presented in Table 5 on page 20 when issuing the command. The

modifiers are presented in Table 26 below.

Table 26 Modifiers

Modifier Description

x.y Length modifier (number of digits and decimal places)

#t Tabulator

#r Carriage-return

#n Line feed

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 156 157

Žádné komentáře

Vaisala DRYCAP DMT345 Uživatelská příručka Strana 90