Vaisala BAROCAP PTB330 Uživatelská příručka stáhnout pdf (Strana 98)

User's Guide ______________________________________________________________________

96 __________________________________________________________________ M210855EN-C

SERI

Use the SERI command to input RS-485 bus settings.

SERI [b p d s]

ECHO

Use the ECHO command to enable/disable echo of characters received

over the serial line.

ECHO [x]

Echo function shall be always disabled (OFF) when using the 2-wire

connection. When using the 4-wire connection you can disable/enable

the echo setting.

SMODE

Use the SMODE command to set the default serial interface mode.

SMODE [xxxx]

where

b = bit rate (300, 600, 1200, 2400, 4800, 9600, 19200, 38400,

57600, 115200)

p = parity (n = none, e = even, o = odd)

d = data bits (7 or 8)

s = stop bits (1 or 2)

where

x = ON/OFF (default = OFF)

where

xxxx = STOP, RUN or POLL

In STOP mode: measurements output only by the command SEND,

all commands can be used.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 137 138

Žádné komentáře

Vaisala BAROCAP PTB330 Uživatelská příručka Strana 98