Vaisala HUMICAP MMT162 Uživatelská příručka Strana 72

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 75
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 71
User's Guide _______________________________________________________________________
70 ___________________________________________________________________ M210934EN-D
APPENDIX A
MODBUS REFERENCE
This appendix describes the Modbus protocol implementation of the
MMT162 transmitter.
Default Communication Settings
Table 12 below shows the default communication settings when Modbus
is enabled at the factory. For information on how to configure the
communication settings using serial line commands, see Table 10 on
page 45.
Table 12 Default Communication Settings
Setting
Default Value
Bit rate
19200
Number of data bits
8
Parity
E
Number of stop bits
1
Device address
240
Response delay
0
Communication mode
MODBUS
NOTE
You can also change device address with Modbus itself (register 1537).
Supported Modbus Functions
Table 13 Supported Function Codes
Function
Code
(decimal)
Function Code
(hexadecimal)
Function Name
(as defined by the specification)
Notes
3
03
Read Holding Registers
See Table 14 on page 71
for available registers.
16
10
Write Multiple Registers
See Table 14 on page 71
for available registers.
43 14
2B 0E
Read Device Identification
See Table 15 on page 72
for available device
identification objects.
NOTE
After power-up, wait for five seconds before sending Modbus requests.
Zobrazit stránku 71
1 2 ... 67 68 69 70 71 72 73 74 75

Komentáře k této Příručce

Žádné komentáře