Vaisala WMS302 Uživatelská příručka stáhnout pdf (Strana 68)

User's Guide ______________________________________________________________________

66 ___________________________________________________________________M210630EN-B

Installing Power Supply

Installing Solar Panel

Usually the solar panel is installed at the factory, and you should only

adjust the tilt angle and check that the connector is attached. In case you

need to install the solar panel, follow the procedure below:

9 = Sensor arm

10 = Hand screw

11 = Telescopic leg

12 = Locking ring and hand screw

13 = Pressure port

14 = Support bar

15 = Ground peg

WARNING

Photovoltaic modules generate direct current (DC) when exposed to

sunlight or other sources of light. Although single modules produce

low voltage and current, shocks and burns can still result from contact

with module output wiring. PV modules do not have to be "connected"

(that is, powering a load) to generate electricity. Since modules

produce electricity whenever light is present, the module should be

completely covered by an opaque cloth or other material before

electrical connections to the modules or other system components are

handled.

WARNING

When working with modules, use properly insulated tools and wear

rubber gloves.

CAUTION

Handle with care: impact on the front or rear surface can damage the

module. Do not bend the module.

NOTE

Do not concentrate light on the module in an attempt to increase its

power output.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 261 262

Žádné komentáře

Vaisala WMS302 Uživatelská příručka Strana 68