Vaisala DMP248 Servisní příručka stáhnout pdf (Strana 97)

APPENDIX 1 SERIAL COMMANDS__________________________________________________________

VAISALA _________________________________________________________________________ 91

ERRS Outputting error messages

ERRS <cr>

During operation error messages are not output automatically through the se-

rial interface. If there is any reason to doubt that there is something wrong with

the transmitter, possible error messages can be output with command ERRS.

If there are no error messages, only a prompt is displayed:

>ERRS <cr>

If errors have occurred, the transmitter outputs the error code (see Appendix 5

for error messages):

>ERRS <cr>

E40 f ( all ) out of range

ECHO Turning the serial interface echo ON/OFF

ECHO xxx <cr>

xxx = ON or OFF

When the echo is off, the commands given through the serial interface or the

prompt > cannot be seen on the display.

When the serial interface is in half-duplex mode, the echo is always off. Even

then the ECHO command can indicate that echo is on.

INTV Setting the output interval for the RUN state

INTV xxx yyy <cr>

xxx = output interval (0...255)

0: no pause between outputs

yyy = unit (s, min or h)

Sets the output interval when the transmitter outputs

measurement readings to a peripheral device.

For example, the currently valid settings are output with:

>INTV <cr>

Output intrv. : 0 min

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 144 145

Žádné komentáře

Vaisala DMP248 Servisní příručka Strana 97