Vaisala HUMICAP HMT330 SERIES Uživatelská příručka stáhnout pdf (Strana 100)

User's Guide ______________________________________________________________________

100 _________________________________________________________________ M210566EN-H

Table 27 Selection of Output Modes

Mode Output Available Commands

STOP Only with the SEND command All (default mode)

RUN Automatic output Only command S

POLL Only with the SEND [addr]

command

Use with RS-485 buses, see

Operation of the RS-485 Module

on page 120.

Selected output mode will be activated after power outages.

INTV

Use the command INTV to set the outputting interval for the RUN mode.

INTV [xxx yyy]

where

xxx = Output interval (0 ... 255). 0: the fastest possible output rate.

yyy = Unit (s, min or h)

Example:

>INTV 10 min

Output intrv. : 10 min

ECHO

Use the command ECHO to set the user port echo. The command either

enables or disables echo of characters received.

ECHO [x]

where

x = ON (default) or

= OFF

NOTE

You can use the SERI, SMODE, INTV and ECHO commands to

change/view the user port settings even if you are currently connected to

the service port.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 177 178

Žádné komentáře

Vaisala HUMICAP HMT330 SERIES Uživatelská příručka Strana 100