Vaisala HUMICAP HMT330 SERIES Uživatelská příručka stáhnout pdf (Strana 72)

User's Guide ______________________________________________________________________

72 __________________________________________________________________ M210566EN-H

Note that activated alarms are only shown on the screen. There are no

alarm messages output to the serial line, or markers placed in the graph

data. After an alarm has been acknowledged, you must refer to the data

graphs to see when the measured quantities have exceeded the limits.

Configuring a Display Alarm

1. Enter the Main Menu by pressing an arrow key on the keypad.

2. Use the arrow keys to select Display, followed by Alarms, to open

the Display Alarms menu. The Display Alarms menu shows the

currently enabled and disabled alarms.

0802-069

Figure 47 Display Alarms

3. Use the arrow keys to select an alarm to configure. The alarm

editing page opens.

NOTE

Changes you do on the alarm editing page will take effect immediately,

and may cause an alarm to appear on the screen.

4. To select a quantity for the alarm, press the Change button and

select the quantity from the list.

5. To modify or remove the alarm limit values, move the selection

over the Act. above or Act. below field and press the Set button.

You will be prompted to Modify or Remove the value.

0802-070

Figure 48 Modifying an Alarm Limit

When modifying the value, use the arrow up and down buttons to

change the value under the cursor. Left and right arrow buttons

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 177 178

Žádné komentáře

Vaisala HUMICAP HMT330 SERIES Uživatelská příručka Strana 72