Vaisala HUMICAP HMT330 SERIES Uživatelská příručka stáhnout pdf (Strana 85)

Chapter 4 ________________________________________________________________ Operation

VAISALA _______________________________________________________________________ 85

3. Check that the other serial/USB line settings are correct for your

connection, and change if necessary. The default settings (shown in

Figure 1) are used by the Service Port of the HMT330.

0810-070

Figure 57 Opening a Serial Connection

4. Click the Open button to open the connection window and start

using the serial line.

If PuTTY is unable to open the serial port you selected, it will show

you an error message instead. If this happens, restart PuTTY and

check the settings.

Opening a Telnet session (LAN/WLAN)

NOTE

The instructions below assume that the LAN/WLAN interface on the

transmitter is correctly configured and the network connection is already

done.

1. Power up the instrument and start the PuTTY application. If your

transmitter acquires a network address using DHCP, wait for a

minute for this to complete, then verify the address from the

transmitter.

2. In the Session window, select the Telnet connection type.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 177 178

Žádné komentáře

Vaisala HUMICAP HMT330 SERIES Uživatelská příručka Strana 85